Cannot engage gear when engine hot

[DanzEterna]

Never read TS first post.......

haha sorry bos...might have overlooked his sentence...

 

[vr2turbo]

haha sorry bos...might have overlooked his sentence...

No problem, you know me, sure tease you if you miss something....hhahahhahaha

 

[punk]

haha sorry bos...might have overlooked his sentence...

haha.

Hey guys, let say i diy this clutch change.

i want to skim my flywheel.

Do i need to worry about the bolt position and torque of the bolt on flywheel.?

let say i mark every bolt position but the tightening bolt part i tight it by hand without torque wrench.
Is it ok?:hmmmm:

 

[DanzEterna]

Ooo ya one more thing, try adjusting your gear lever, might have misaligned.

 

[vr2turbo]

Ooo ya one more thing, try adjusting your gear lever, might have misaligned.

Misaligned will be hard to engage all the time, right? Why only when hot?

 

[DanzEterna]

Misaligned will be hard to engage all the time, right? Why only when hot?

cos the tapak of the gear lever has bushings rite, if its worn out will effect gear change.
could try check it out though.

 

[vr2turbo]

cos the tapak of the gear lever has bushings rite, if its worn out will effect gear change.
could try check it out though.

Yah! then hot or cold also hard to engage mah.....

 

[punk]

mine only when engine run for around 10km then very hard to engage gear already.

Before 10km, gear still can engage no problem.

 

[vr2turbo]

mine only when engine run for around 10km then very hard to engage gear already.

Before 10km, gear still can engage no problem.

Then need change gear oil...Try 75w-90 viscosity or add gear oil additives....

 

[punk]

Then need change gear oil...Try 75w-90 viscosity or add gear oil additives....

Later update if the problem solved.