no la... its all about 'sciences'...:proud:that sounds a bit hamsap
no la... its all about 'sciences'...:proud:that sounds a bit hamsap
but now, u just port the outer part, haven't port the inside part.... mayb after port the inside will get better 'feel' ler..???:proud:unker, I both top and lower part is port.....only satisfied...if port only 1 place result not so satisfied.
Be careful when doing this. Don't overport until the butterfly flap cannot close properly. If there's leakage your idling is gonna be a pain in the ass.TitanRev san...two thumbs up......recently, i cleaned the throttle body by using carb cleaner...then, I found out your DIY....this would be my next DIY project...well, how long it takes to polish the inner TB ??....
What do you mean not fully closed? Is the flap spring pulling the butterfly closed or just half way or slightly open? If slightly it might be on purpose depending on what car you drive. It can't be completely sealed otherwise your car wouldn't be able to idle.sifuses & bros, if i'm not mistaken, the butterfly should fully closed when tb is cold but mine is not, is this a prob that needs to be solve??
hmmm, maybe later on i'll take a picture & post it here, btw thanx for your kind opinion hope i can learn more & not just drive & clean my wallet when the time comesWhat do you mean not fully closed? Is the flap spring pulling the butterfly closed or just half way or slightly open? If slightly it might be on purpose depending on what car you drive. It can't be completely sealed otherwise your car wouldn't be able to idle.