Was walking around with my mum in this plastic store,
saw a nice item to be made into heat shield,
rm4.90 , dustbin , use a saw or cutter, n that all it was needed for
a 6" open pod , here are the pics , the front opening of the filter meets my cold air intake
when you install a heat shield make sure u still have ambient air that can reach your filter easily. I have seen some heatsheilds that cause more harm than good by limiting the circulating air around the filter.
If you have a cold air intake then it should be good to go already, if not then it is going to be pretty restrictive.
I just use a sunshade cut it out and cover it around my open pod.
I agree with mokomoko. I used to use an open pod that was encased in a cylinder type of carbon fibre casing as heat shield. I felt it couldn't suck in enuff volume of air. When I change it to Apexi open pod, I could instantly feel the difference.
guys and sifu here....my car is LMST i want to float up the front bonet about 1CM gap. Purpose is not to show off or what but i really need the air circulation because i am using Apexi Open Port. Really need to release trapped hot air in the...