Trumpet for Blacktop 4-Throttle

AndrewMIVEC

Senior Member
Joined
Aug 23, 2007
Messages
3
Points
1,503
Hi, anybody out there can machine (aluminium) trumpets for the Toyota Blacktop 4 throttle?

Hole diameter start at 49mm and grow to around 70mm at 75mm height... or any other custom dimensions??

Rgds,
Andrew
 
Hai Andrew
I got stanlessteel trompet for black top
give u'r pn no...I send the pic for u....
 
refer to ur requirement, theres got a few basic spec u can follow & if u ask for more, then u hav to calculated the cubic & ur needs...
 
jdm from halfcut..some member said the long neck good for STV n the short neck for BTV''
sorry if wrong...
 
u'r right... but not all..
not to says so...
its all depends on wat u wan 7 how u wish ur engine can be... mayb can b more easy, short & fat is more to higher rev which no bother the low end toq at all, while tall/slim 1, is more to 'Balance'...
difren cam will have difren setup...
 
you all right...must be right set-up..tambah itu and tambah ini if not sengok-sengok.he hee
 
u'r right... but not all..
not to says so...
its all depends on wat u wan 7 how u wish ur engine can be... mayb can b more easy, short & fat is more to higher rev which no bother the low end toq at all, while tall/slim 1, is more to 'Balance'...
difren cam will have difren setup...

Bro.. Care to explain? Got such thing as trumpet tuned for low-end torque? I thought once we go trumpet, we can forget about low end already? Can we still get low-end torque if use trumpet?

And... lets say we use long and slim ones, which is for low-end torque, is it better than the low end torque for stock filter/open pod/CAI?

Thank you...
 
of course ... matter of fact ... changing to CAI/exhaust also it would be proper if u do tuning ... then only u can fully utilise it :)
 

Similar threads

Posts refresh every 5 minutes




Search

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience