My ceFIRO

[weikee]

on the OD in 3L fatty, you feel the power in high speed.

 

[seizai]

where is washer pump locate? all car same or must fit back a32 one?

 

[dream.tent]

According to the parts dealers....it's a shared part between a few Nissan car Models...

You Google it you will know. Sama Sama looks.

 

[seizai]

According to the parts dealers....it's a shared part between a few Nissan car Models...

You Google it you will know. Sama Sama looks.

wat is that part called? google very hard find all come out the water tank

 

[dream.tent]

wat is that part called? google very hard find all come out the water tank

Bro, he is looking for washer pump you see. So i just google Nissan A32 Washer Pump and this pops up...
http://www.car-stuff.com/nissanwasherpump.htm

 

[seizai]

this thing cost me 45... haiz..

 

[doraemon98]

Wah so expensive! You bought used one or new one?

 

[seizai]

new one... used one no body wanna sell

 

[seizai]

Project "hack" d headlamp...

Left side

Right side

Never thought it hv 2.5in

ok.. project begin
1)Drop clips

2)Remove covers & bulbs

3)Use spanar & heat gun to make opening. If u plan use back lamp cover dun follow me...

4)At last...

5)After remove cover

6)Mission complete

 

[sb3]

What project is this ?. Is it installing projector lights or removing it?

 

[Kevin Lee]

sounds like a very very long cefiro project, do u have backup cars

 

[seizai]

part2... still looking housing for it

 

[Kevertz]

near to the driver seat. you see a small vent. that is where it sense the temperatue, than got a Infra red or was it heat detector on the front dash board.

Bros weikee, My A32 3.0 also facing the same problem a/c compressor dont cut off also went i put into 32c. Some ac mechanic told me my A32 ac intake sensor missing?

 

[weikee]

If it missing you need to get the replacement from chop shop or new unit.

 

[wuss]

hey i recently lowered my a33 cefiro and the cv joint keep making noise even when i drive straight i realy dont want to raise it cuz it looks really kewl...is there anything i can do to the axle or even buy something to combat this problem....p.s i changed like about 3 pairs of new joints already...problem still persists

 

[Cheongxp]

Hi Wuss,
Wish to know you lowered by change to adjustable or just sport spring ?
Thinking to change absorber, but couldn't make decission to go original absorber + Sport spring or Adjustable Absorber.
I travel a lot with this car in town & sometime with family member too.
Existing was too soft, wonder is Absorber gone or original setting was soft like this.

 

[wuss]

no it isnt...i have ona set of d2's in the front and once u drop it a certain height it makes the cv joint go bad...i really dont knw how to solve the problem...one guy told me he does something to the axle that makes u drop as low as u want,,,buh i want confermation...it really is frustrating,...i cant lower my car the height i want it cuz the cv joint keeps gettin ruined...

 

[Cheongxp]

Hi Wuss,
Ic, I heard a lot of complaint once lowered down to much. Wonder becos of VQ engine weight & wide car body.
But the way, how much you low down ?
I still keep at original setting, but i happen travel at Karak highway chase a BMW 5 series, can chase him close, but when reach uneven road like Karak Highway design, alamak my car look like can't handle & can't make the car slide left to right side or Right to left.
Suspect absorber gone liao !!

 

[sb3]

Go for height adjustable units , then lower it down to the limit before it stresses your cv joints . Another option is to get huge rims with higher profile tires so you don't have to lower the car and it will look stunning !.

 

[wuss]

hey SB3
i have on 20's right now and adjustable d2 shocka dn soring coilovers....but the car once lowered to the tired height or even a little higher still causes the joints to fail...i dnt knw if the symetry of the vehicle is off but i see a lot of these lowered very low all over the net i was wondering if there is a shorter axle or better bigger cv joint ppl use...