FS: Used ori honda civic 99 front bumper with mugen lip

Status
Not open for further replies.
Exterior and Body

FS: Used ori honda civic 99 front bumper with mugen lip

steviezach

Known Member
Senior Member
Thread starter
Feb 1, 2005
191
3
3,018
thanks ketip for helping me to reply him...
i kenot online alwiz..cos got no internet at home aredi ....
 

Opt-ion

500 RPM
Senior Member
Feb 7, 2006
667
1
1,518
jus wan to know why u sell it? R u istalling a new 99spec into ur's?
is the lip tw or ori? go the grille too...
 

steviezach

Known Member
Senior Member
Thread starter
Feb 1, 2005
191
3
3,018
bcos i aredi changed to new bumper......wan to install other type of fog lights
the lip is tw...as i know ..if u wanna find ori mugen lip..its hard to get in malaysia and very very expensive..cost about rm1k.......mine is PU material ...wont break but not include grille...
 

Opt-ion

500 RPM
Senior Member
Feb 7, 2006
667
1
1,518
Soree, 1 more question...

why u wan to change a new bumper to install fog lights?

can't u jus install direct to the open side air vent holes???

where r u located?
 

jien

Known Member
Senior Member
Nov 22, 2005
66
0
1,506
location is subang jaya, for more information pls call 0195752026.
 

steviezach

Known Member
Senior Member
Thread starter
Feb 1, 2005
191
3
3,018
Opt-ion said:
Soree, 1 more question...

why u wan to change a new bumper to install fog lights?

can't u jus install direct to the open side air vent holes???

where r u located?
can install....but i prefer the bumper without the round foglights...
 

jien

Known Member
Senior Member
Nov 22, 2005
66
0
1,506
steve : let's sell it to junkyard, together with my rear trunk. ho ho ho...
 
Status
Not open for further replies.

Random Post Every 5 Minutes

Hi all taiko taiko, i hope this thread is in the correct section....

First, I drive Honda Prelude 4th gen.

finger gap between my front tire and fender is 3, both normal, but at the rear side, it becomes:

rear passenger side = 4 finger
rear driver side = 3 finger.

both original absorber, my mech got no clue on it. I already changed:

1. upper arm ball joint / bush
2. lower arm ball bush
3. ARB end link
4. switching between ori absorber and Tein adjustable.

but the problem...
Ask a question, start a discussion or post something for sale!
Post thread

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience