DIY Gauge Holder / Pod

[donCityZ]

This is good DIY.. end result nice..

but i always want to know 1 thing.. does it introduce
any new dashboard noise?

 

[type_one]

Nope, not if you drill the holes ngam ngam to fit the elbows.. if its loose, then definitely will creak a little....

 

[Edward Chew]

Wow. Great work. Very nice job. May i know where did you get the plastic clipboard??? Very desperate hunting for that material le... hehe

 

[type_one]

Any stationery shop bro.... it comes in different colours... blue black green... with the clip on top or at the side, to clip paper... but its irrelevant cuz ur only using part of it...
Or better still, buy the thick folders with pvc or vinyl cover.. so it'll LOOK a bit like leather to match ur dashboard...
But have to be careful with the edges..or else won't look nice... Good Luck!

 

[Edward Chew]

Thick folder with PVC or Vinyl Cover??? Where to get? I'll look for it. hehe
Really thanks for the info.

 

[type_one]

HAHA.... same lar... any book store.. or stationery shop.. i just did mine again today..
but didn't take pictures.. will post pics later.. this time i used a clipboard with vinyl cover, and U-shaped pipe clamps...

 

[Edward Chew]

Hey. Is that board called cutting mad also? I just bought one from popular today, 45cm x 30cm x 3mm for RM14... Looks like rubber material la... Hehe. Suddenly got a lot ideas pop in mind using this material for various diy...

 

[type_one]

Cutting mat? ooh... with all the lines on it? not exactly what i had in mind, but i think it'll do just fine.....good luck!