VW Polo TSI: Opti-Coated #2

[muyo]

Good afternoon,

Again Hypergloss Detailing bringing another Opti-Coated VW Polo! since this month really gets me busy all the time and finally got some time to post before im getting busy again! recently just done a Opti-Coated Golf GTI and another exterior/interior detailing Honda FD2, not forget another interior detailing Audi A4 B7. hopefully i can get all the other cars done before Christmas, fella readers please wait for my upcoming detailing post! and also million thanks to all readers who follow my blog for all these while! here i have is a few months old Polo to detail.

enjoy!


upon arrival

always love to start with the wheel 1st

tadaa!

OPC wash with a pale of water to rinse microfiber

re-wash with ONR and clay at the same time

after good surface preparation, inspection begins..

after corrected

close up

before

after

after wipe down with IPA, coating begin..

after 6hours later..

and finally..

end.


thanks for reading!

 

[fizdetail]

great work buddy!!

 

[Veloc]

Another complete detail including engine bay... U very kuat. As the name says... Hypergloss...
Good job bro!

 

[Mr.JY]

I always do the direct opposite of what you do, Muyo. I always deal with the wheel last, fear that the dirty stains from the body might dirty the wheel I cleaned earlier. Or am I over-thinking? :sleep:

 

[muyo]

great work buddy!!

Thanks bro.

---------- Post added at 07:53 PM ---------- 6 hour anti-bump limit - Previous post was at 07:49 PM ----------

Another complete detail including engine bay... U very kuat. As the name says... Hypergloss...
Good job bro!

Haha! No la.. love seeing the car I restored. You also just wut. Especially the headlamp you did recently.

---------- Post added at 08:17 PM ---------- 6 hour anti-bump limit - Previous post was at 07:53 PM ----------

I always do the direct opposite of what you do, Muyo. I always deal with the wheel last, fear that the dirty stains from the body might dirty the wheel I cleaned earlier. Or am I over-thinking? :sleep:

Hi bro. Cause I love to deal with the dirtiest part first before on paintwork. After clean the wheels when is still wet I will move to the paintwork. Dirt of course will fall abit but is just sand and some dirt. Just simply rinse off will do. If wash the body first then rims, I might afraid the brake dust will spread on the surface since it will caused swirls. If you rinse it properly you won't have any issue. Haha, just my thoughts. Work on rims or paintwork I think is the same. Just becareful lo.

 

[Mr.JY]

I never actually thought of that. Learnt something today, Muyo! Kaotow to you

 

[blitztomato]

where are u guys gets the ipa from? it is from pharmacy ???

 

[SevenDust]

Awesome work Mun! Missed the coating for this haha. Keep up the good work!

 

[seech]

Great post mun!!! Very detailed step-by-step...