danz..
Erm.. Looks like so 'kacau' if use e3 lancer n e3 wira lorh..huhu..
My fren use ori e3 also kena tahan with jpj too n looked at da grant.. After da jpj were know thts he tahan an ori.. My fren looked da jpj face is really ashammed lor..huhu.. My fren just a lil smile to him too..huhu.
My car also 2,3 times also kena tahan.. But, da jpj just look my conversion engine dcument..he just round over my car n see da
e3 bodypart..xhaust piping..n engine.. Just dont sombong la with him..talk slowly n we must look confident in front of him..just a
lil sembang2 lor..huhu.
About da rear that u sggest.. Actually its was already in my planning too.. Rear bonet evo kacuk with wira's bonnet that hav a
curve, reflector, n plate holder.. I look n i think ok la 4 a bit transplant like this.. Also abit peace my mind a lil.. Huhu..
---------- Post added at 11:23 PM ---------- 6 hour anti-bump limit - Previous post was at 11:17 PM ----------
just4z..
No boring if we done our car at the right stuft.. Matured modes.. And da intelligent modification..
Thats all..
:proud:
---------- Post added at 11:23 PM ---------- 6 hour anti-bump limit - Previous post was at 11:23 PM ----------
just4z..
No boring if we done our car at the right stuft.. Matured modes.. And da intelligent modification..
Thats all..
:proud:
---------- Post added at 11:46 PM ---------- 6 hour anti-bump limit - Previous post was at 11:23 PM ----------
how can wira install evo rear transaxle case? is cut n paste or can unwelding and welding back?
u meant want to install 4wd?
1. Get the lantai belakang evo
2. cut n weld back on to wira's floor
3. Install togather with evo rear transaxle completely
4. Trade in ur 4wd lock 2wd gb at da halfcut shop to fulltime 4wd evo gb with long shaft.. (u cannot relock ur current 4wd gb n buy another
long shaft n then u fix it.. It can broken ur 4wd gb coz the teeth at da gb n that long shaft is cannot be same..
5. Make da full balancing ur engine..
6. Importance.. Makesure goes to da right wkshop n experiance foremen...
Good luck..