Where to do chassis repair and strengthening in PJ/KL/Subang?

minibeany

500 RPM
Senior Member
Apr 30, 2017
598
101
543
Petaling Jaya
Why are they getting stripped bare? That issue often plays on my mind. How does one check if it's still roadworthy?
now selling the whole car is worthless. my mechanic just bought a Wira A/B 1.5 for RM1000. You can make more by selling parts. If nobody want the body, they will cancelled it in JPJ
 

parakey

1,000 RPM
Senior Member
Apr 30, 2012
1,367
226
663
Kuala Lumpur
now selling the whole car is worthless. my mechanic just bought a Wira A/B 1.5 for RM1000. You can make more by selling parts. If nobody want the body, they will cancelled it in JPJ
If whole car is 1K, then sanekit better take whole car and swap the engine only. No need to do doors, boot, bonnet, chairs, dashboard, wiring, roof lining .. etc.

Really a no brainer
 

vr2turbo

Beyond 20,000 RPM!
Helmet Clan
Moderator
May 11, 2010
29,998
8,385
1,713
Petaling Jaya
yes. this is the right side frame. this side memang goes inside a bit. the left side is straight.
That was the fender you did DIY at my house? some nuts not match the hole and one kept turning but won't come off.....
 

sanekit

1,500 RPM
Thread starter
Dec 9, 2015
1,616
157
663
Petaling Jaya
That was the fender you did DIY at my house? some nuts not match the hole and one kept turning but won't come off.....
yeah. hahaha. due to the shoddy workmanship, the right side got rust spots. my driver door or koyak coz of rust and the welding seam crack as well. if u remember, i went and weld the seam back coz water coming in from there. bottom right corner of the windshield.
 

vr2turbo

Beyond 20,000 RPM!
Helmet Clan
Moderator
May 11, 2010
29,998
8,385
1,713
Petaling Jaya
yeah. hahaha. due to the shoddy workmanship, the right side got rust spots. my driver door or koyak coz of rust and the welding seam crack as well. if u remember, i went and weld the seam back coz water coming in from there. bottom right corner of the windshield.
I bought a gasless inverter welder already. You can test weld DIY, but don't blow up the car......hahhahhahahhaha
 

Random Post Every 5 Minutes

Hi everyone,

Before I started here, I was lookout in Achieve but couldn’t fine any topics which can help, so here my scenario and questions.

My Machine 4G61NA, with 1.8 head cylinders, but currently need to be overhauling the engine. Therefore I decided to upgrade at the same time as well. In my mind was thinking about 1.8 or 2.0NA, now my questions is what are the 1.8 or...
Ask a question, start a discussion or post something for sale!
Post thread

Online now

Enjoying Zerotohundred?

Log-in for an ad-less experience