DIY Port & Polish Throttle Body (guide)

[JINEIL2EN]

unker fred wanna feel his car..??

 

[TitanRev]

unker, acceleration did improved and the rev also goes up faster especially during the low range but still slower than your Gymkhana monster...

Izso, yeah..you are right...the butterfly valve area cannot touch....can only do the area before the BV and after the BV.

Arturo, wah quite expensive....

 

[TitanRev]

ofcos la... haha

cos the main point is not to port it bigger, but smoother... just like how u done to ur throttle ma...

I think my hand will become cacat after that...

 

[Izso]

TR taikor, after u did d porting a bit... did u feel any difference in acceleration?

Eh taikor.. I tot you tukar to T3t3k besar (TB) besar already? Nothing beats a bigger TB but low end will be a bit hard to control so I'm told.

when you gonna to twin t3t3k besar?

 

[JINEIL2EN]

if just doing the front part, thats will lead the venturi effect, air will be compress & better air flow... nice...

 

[TitanRev]

I also want TTB...Hehehehe

 

[JINEIL2EN]

I think my hand will become cacat after that...

won't la bro.... slow slow do ma....

 

[Izso]

I also want TTB...Hehehehe

Without meaning to sound off topic - the twin TB setup has actually been done with really good results.

 

[fstr]

just now i kasi sand my extra tb, sand till finger also can putus liow

 

[JINEIL2EN]

unker, i reco u using 1 kayu round shape with dish wash sponge with a layer of double side tape then with the sand paper on the outer layer... that shld save ur finger...

 

[TitanRev]

unker old already....Hahahaha....

 

[JINEIL2EN]

me too... TR still young... so good...

 

[fstr]

i think if u port the bottom u get finer low ends and if u port the top part u get slightly mid end...

true guys?

 

[JINEIL2EN]

hehe... port the lower end, decrease fiction from the start...haha...:embarassed:

 

[fstr]

hehe... port the lower end, decrease fiction from the start...haha...:embarassed:

that sounds a bit hamsap